NHTSA Vehicles recall ·
Terex Pole Position Guide ARM Assembly PIN recall: Cracked Weld May Cause Pole Guide Arm to Fall
- Recall number
- 26E016000
- Date
- Manufacturer
- Terex South Dakota, Inc.
- Category
- Vehicles
- Recall type
- Equipment
- Units affected
- 3015
- Hazard tags
- Fall Injury risk
Read the official NHTSA notice ↗
Affected vehicles
| Make | Model | Model years |
|---|---|---|
| Terex | Pole Position Guide ARM Assembly PIN | — |
Not every vehicle of these models is affected. Enter your 17-character VIN on NHTSA.gov to check your vehicle.
Why was it recalled?
Terex South Dakota, Inc. (Terex) is recalling certain pole position guide arm assembly pins with part number 450543. An insufficient weld on the plate weldment may crack, causing the retaining pin to separate.
Consequence
Without a retaining pin, the pole guide arm may fall, increasing the risk of injury to people around the truck.
What should you do?
Owners will inspect the plate weldment for any cracks or abnormal welds. Dealers or owners will replace the plate weldment as necessary, free of charge. Owner notification letters were mailed June 2, 2026. Owners may contact Terex's customer service at 1-605-882-4000. Terex's number for this recall is SN737E.
Manufacturer campaign number
SN737E
Source: NHTSA (vehicles), recall 26E016000. Official notice. Republished from public data; RecallFlag is not affiliated with the NHTSA.